PVC Corrugated Conduit Ø16/10.7 mm with Pull Wire, 50 m, 1416E_K50D

The 1416E_K50D corrugated electrical conduit with an outer diameter of 16 mm is designed for the protection and routing of electrical, signal, data and low-voltage cables. It is manufactured from durable PVC in a light grey finish and comes with an integrated pull wire, which makes cable installation faster and easier.

The conduit is suitable for both surface-mounted and concealed installations, including installation on walls and ceilings, in screed, under plaster, and inside hollow-wall structures. Its flexible corrugated design makes it convenient for routing cables through areas with bends and complex installation paths.

A mechanical resistance of 320 N/5 cm provides reliable protection against moderate mechanical loads during installation and operation. The operating temperature range is -5 to +60 °C.

Key Advantages

• Integrated pull wire for easier cable installation.
• 16 mm outer diameter — a commonly used size for residential and professional electrical installations.
• Minimum inner diameter: 10.7 mm.
• Mechanical resistance: 320 N/5 cm.
• Made from durable PVC.
• Light grey colour.
• Suitable for installation under plaster, in screed, walls, ceilings and hollow structures.
• Suitable for installation in specified potentially explosive areas.
• Supplied in a 50 m coil.

Technical Specifications

• Type: corrugated electrical conduit with pull wire
• Model: 1416E_K50D
• Material: PVC
• Colour: light grey
• Outer diameter: 16 mm
• Minimum inner diameter: 10.7 mm
• Coil length: 50 m
• Length tolerance: ±1%
• Mechanical resistance: 320 N/5 cm
• Operating temperature: -5 to +60 °C
• Weight: 0.05 kg/m
• Design: with integrated pull wire
• Classification code: 22212
• Standard: ČSN EN 61386-1 ed.2
• Reaction to fire of base material: A1–F

Applications

The corrugated conduit is suitable for routing:

• power cables;
• lighting cables;
• network and telecommunication cables;
• alarm and security system cables;
• other low-voltage wiring.

It can be installed on surfaces, in screed, under plaster, inside hollow or plastered walls, and in ceiling structures.

The conduit may also be installed in Zone 2 areas with a risk of explosive combustible gases and vapours, as well as in Zone 22 areas with a risk of combustible dust explosions, subject to applicable installation requirements and regulations.

Manufacturer's recommendation: plastic conduit installation is recommended at ambient temperatures above 0 °C.

The Ø16/10.7 mm PVC corrugated conduit with pull wire, 1416E_K50D is a practical solution for fast, neat and protected cable routing in residential, commercial and industrial electrical installations.